Link Aggregation Control Protocol; Lacp Modes - Cisco ME 3400 Software Configuration Manual

Understanding EtherChannels
In Layer 2 EtherChannels, the first port in the channel that comes up provides its MAC address to the
EtherChannel. If this port is removed from the bundle, one of the remaining ports in the bundle provides
its MAC address to the EtherChannel.
PAgP sends and receives PAgP PDUs only from ports that are up and have PAgP enabled for the auto or
desirable mode.

Link Aggregation Control Protocol

The LACP is defined in IEEE 802.3ad standard and enables Cisco switches to manage Ethernet channels
between switches that conform to the standard. LACP facilitates the automatic creation of
EtherChannels by exchanging LACP packets between Ethernet ports.
LACP is available only on NNIs and ENIs.
Note
By using LACP, the switch learns the identity of partners capable of supporting LACP and the
capabilities of each port. It then dynamically groups similarly configured ports into a single logical link
(channel or aggregate port). Similarly configured ports are grouped based on hardware, administrative,
and port parameter constraints. For example, LACP groups the ports with the same speed, duplex mode,
native VLAN, VLAN range, and trunking status and type. After grouping the links into an EtherChannel,
LACP adds the group to the spanning tree as a single switch port.

LACP Modes

Table 34-2
configuration command on an NNI or ENI.
Table 34-2
Mode
active
passive
Both the active and passive LACP modes enable ports to negotiate with partner ports to an
EtherChannel based on criteria such as port speed and, for Layer 2 EtherChannels, trunking state and
VLAN numbers.
Ports can form an EtherChannel when they are in different LACP modes as long as the modes are
compatible. For example:
•
•
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
34-6
shows the user-configurable EtherChannel LACP modes for the channel-group interface
EtherChannel LACP Modes
Description
Places a port into an active negotiating state in which the port starts negotiations with other
ports by sending LACP packets.
Places a port into a passive negotiating state in which the port responds to LACP packets
that it receives, but does not start LACP packet negotiation. This setting minimizes the
transmission of LACP packets.
A port in the active mode can form an EtherChannel with another port that is in the active or passive
mode.
A port in the passive mode cannot form an EtherChannel with another port that is also in the passive
mode because neither port starts LACP negotiation.
Chapter 34 Configuring EtherChannels and Link-State Tracking
OL-9639-07