Cisco ME 3400 Software Configuration Manual page 223

Chapter 9 Configuring Interfaces
Command
Step 3
no shutdown
Step 4
interface range macro macro_name
Step 5
end
Step 6 show running-config | include define
Step 7 copy running-config startup-config
Use the no define interface-range macro_name global configuration command to delete a macro.
When using the define interface-range global configuration command, note these guidelines:
•
•
•
•
This example shows how to define an interface-range named enet_list to include ports 1 and 2 and to
verify the macro configuration:
Switch# configure terminal
Switch(config)# define interface-range enet_list gigabitethernet0/1 - 2
Switch(config)# end
Switch# show running-config | include define
define interface-range enet_list GigabitEthernet0/1 - 2
OL-9639-07
Valid entries for interface-range:
vlan vlan-ID - vlan-ID, where the VLAN ID is 1 to 4094
–
fastethernet module/{first port} - {last port}, where the module is always 0
–
– gigabitethernet module/{first port} - {last port}, where the module is always 0
– port-channel port-channel-number - port-channel-number, where the port-channel-number
is 1 to 48.
Note When you use the interface ranges with port channels, the first and last port channel number
must be active port channels.
You must add a space between the first interface number and the hyphen when entering an
interface-range. For example, gigabitethernet0/1 - 2 is a valid range; gigabitethernet0/1-2 is not
a valid range.
The VLAN interfaces must have been configured with the interface vlan command. The show
running-config privileged EXEC command displays the configured VLAN interfaces. VLAN
interfaces not displayed by the show running-config command cannot be used as interface-ranges.
All interfaces defined as in a range must be the same type (all Fast Ethernet ports, all Gigabit
Ethernet ports, all EtherChannel ports, or all VLANs), but you can combine multiple interface types
in a macro.
Purpose
Enable the port, if necessary. By default, UNIs and ENIs are disabled,
and NNIs are enabled.
Select the interface range to be configured using the values saved in
the interface-range macro called macro_name.
You can now use the normal configuration commands to apply the
configuration to all interfaces in the defined macro.
Return to privileged EXEC mode.
Show the defined interface range macro configuration.
(Optional) Save your entries in the configuration file.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
Using Interface Configuration Mode
9-11