Resequencing Aces In An Acl; Creating Named Standard And Extended Acls - Cisco ME 3400 Software Configuration Manual

Configuring IPv4 ACLs
After creating a numbered extended ACL, you can apply it to terminal lines (see the
ACL to a Terminal Line" section on page
Interface" section on page
page

Resequencing ACEs in an ACL

Sequence numbers for the entries in an access list are automatically generated when you create a new
ACL.You can use the ip access-list resequence global configuration command to edit the sequence
numbers in an ACL and change the order in which ACEs are applied. For example, if you add a new ACE
to an ACL, it is placed at the bottom of the list. By changing the sequence number, you can move the
ACE to a different position in the ACL.
For more information about the ip access-list resequence command, see this URL:
http://www.cisco.com/univercd/cc/td/doc/product/software/ios122s/122snwft/release/122s14/fsaclseq.
htm

Creating Named Standard and Extended ACLs

You can identify IPv4 ACLs with an alphanumeric string (a name) rather than a number. You can use
named ACLs to configure more IPv4 access lists in a router than if you were to use numbered access
lists. If you identify your access list with a name rather than a number, the mode and command syntax
are slightly different. However, not all commands that use IP access lists accept a named access list.
The name you give to a standard or extended ACL can also be a number in the supported range of access
Note
list numbers. That is, the name of a standard IP ACL can be 1 to 99; the name of an extended IP ACL
can be 100 to 199. The advantage of using named ACLs instead of numbered lists is that you can delete
individual entries from a named list.
Consider these guidelines and limitations before configuring named ACLs:
•
•
•
•
Beginning in privileged EXEC mode, follow these steps to create a standard ACL using names:
Command
Step 1 configure terminal
Step 2 ip access-list standard name
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
31-14
31-19), or to VLANs (see the
31-29).
Not all commands that accept a numbered ACL accept a named ACL. ACLs for packet filters and
route filters on interfaces can use a name. VLAN maps also accept a name.
A standard ACL and an extended ACL cannot have the same name.
Numbered ACLs are also available, as described in the
ACLs" section on page 31-7.
You can use standard and extended ACLs (named or numbered) in VLAN maps.
Chapter 31
31-18), to interfaces (see the
"Configuring VLAN Maps" section on
"Creating Standard and Extended IPv4
Purpose
Enter global configuration mode.
Define a standard IPv4 access list using a name, and enter
access-list configuration mode.
The name can be a number from 1 to 99.
Note
Configuring Network Security with ACLs
"Applying an IPv4
"Applying an IPv4 ACL to an
OL-9639-07