Disabling And Enabling Lldp Globally; Disabling And Enabling Lldp On An Interface - Cisco ME 3400 Software Configuration Manual

Chapter 24 Configuring LLDP and LLDP-MED

Disabling and Enabling LLDP Globally

LLDP is disabled globally by default and is enabled on NNIs. It is disabled by default on ENIs, but can
be enabled per interface. LLDP is not supported on UNIs.
Beginning in privileged EXEC mode, follow these steps to globally disable LLDP:
Command
Step 1 configure terminal
Step 2
no lldp run
Step 3
end
Beginning in privileged EXEC mode, follow these steps to enable LLDP-MED when it has been
disabled:
Command
Step 1 configure terminal
Step 2
lldp run
Step 3 end
This example shows how to globally disable LLDP.
Switch# configure terminal
Switch(config)# no lldp run
Switch(config)# end
This example shows how to globally enable LLDP.
Switch# configure terminal
Switch(config)# lldp run
Switch(config)# end

Disabling and Enabling LLDP on an Interface

LLDP is disabled by default on all NNIs to send and to receive LLDP information. It is disabled by
default on ENIs, but it can be enabled by entering the lldp transmit and lldp receive interface
configuration commands. LLDP is not supported on UNIs.
If the interface is configured as a tunnel port, LLDP is automatically disabled.
Note
Beginning in privileged EXEC mode, follow these steps to disable LLDP on an interface.
Command
Step 1
configure terminal
Step 2
interface interface-id
OL-9639-07
Purpose
Enter global configuration mode.
Disable LLDP.
Return to privileged EXEC mode.
Purpose
Enter global configuration mode.
Enable LLDP.
Return to privileged EXEC mode.
Purpose
Enter global configuration mode.
Specify the interface on which you are disabling LLDP, and enter
interface configuration mode. The interface must be an NNI or ENI
for the lldp commands to be available.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
Configuring LLDP and LLDP-MED
24-5