Displaying Ipv6 Acls - Cisco ME 3400 Software Configuration Manual

Displaying IPv6 ACLs

Displaying IPv6 ACLs
You can display information about all configured access lists, all IPv6 access lists, or a specific access
list by using one or more of the privileged EXEC commands in
Table 37-1 Commands for Displaying IPv6 Access List Information
Command
show access-lists
show ipv6 access-list [access-list-name]
This is an example of the output from the show access-lists privileged EXEC command. The output
shows all access lists that are configured on the switch or switch stack.
Switch #show access-lists
Extended IP access list hello
IPv6 access list ipv6
This is an example of the output from the show ipv6 access-lists privileged EXEC command. The output
shows only IPv6 access lists configured on the switch or switch stack.
Switch# show ipv6 access-list
IPv6 access list inbound
IPv6 access list outbound
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
37-8
10 permit ip any any
permit ipv6 any any sequence 10
permit tcp any any eq bgp (8 matches) sequence 10
permit tcp any any eq telnet (15 matches) sequence 20
permit udp any any sequence 30
deny udp any any sequence 10
deny tcp any any eq telnet sequence 20
Purpose
Display all access lists configured on the switch.
Display all configured IPv6 access list or the access list specified by
name.
Chapter 37 Configuring IPv6 ACLs
Table 37-1.
OL-9639-07