Cisco ME 3400 Software Configuration Manual page 667

Chapter 33 Configuring QoS
Command
Step 5
conform-action cos {cos_value | cos [table
table-map-name] | dscp [table
table-map-name] | precedence [table
table-map-name]}
or
conform-action [ip] dscp {dscp_value | cos
[table table-map-name] | dscp [table
table-map-name] | precedence [table
table-map-name]}
or
conform-action [ip] precedence
{precedence_value | cos [table
table-map-name] | dscp [table
table-map-name] | precedence [table
table-map-name]}
or
conform-action qos-group value
or
transmit
OL-9639-07
Purpose
(Optional) Enter the action to be taken on packets that conform to
the CIR.
• For cos cos_value, enter a new CoS value to be assigned to the
classified traffic. The range is 0 to 7.
For [ip] dscp dscp_value, enter a new DSCP value to be
•
assigned to the classified traffic. The range is 0 to 63.
For [ip] precedence precedence_value, enter a new
•
IP-precedence value to be assigned to the classified traffic. The
range is 0 to 7.
Or you can configure a CoS, DSCP, or IP precedence table and
•
optionally enter the table name. If you do not enter table
table-map name, the table map default behavior is copy. See the
"Configuring Table Maps" section on page
For qos-group value, identify a QoS group to be used at egress
•
to identify specific packets. The range is from 0 to 99.
You can enter a single conform-action as part of the
Note
command string following the police command. You can
also press Enter after the police command to enter
policy-map class police configuration mode, where you can
enter multiple actions. In policy-map class police
configuration mode, you must enter an action to take.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
Configuring QoS
33-36.
33-41