Reconfirming Vlan Memberships; Changing The Reconfirmation Interval; Changing The Retry Count - Cisco ME 3400 Software Configuration Manual

Chapter 11 Configuring VLANs
To return an interface to its default configuration, use the default interface interface-id interface
configuration command. To reset the access mode to the default VLAN for the switch, use the no
switchport access vlan interface configuration command.

Reconfirming VLAN Memberships

Beginning in privileged EXEC mode, follow these steps to confirm the dynamic-access port VLAN
membership assignments that the switch has received from the VMPS:
Command
Step 1 vmps reconfirm
Step 2 show vmps

Changing the Reconfirmation Interval

VMPS clients periodically reconfirm the VLAN membership information received from the VMPS.You
can set the number of minutes after which reconfirmation occurs.
Beginning in privileged EXEC mode, follow these steps to change the reconfirmation interval:
Command
Step 1
configure terminal
Step 2 vmps reconfirm minutes
Step 3 end
Step 4 show vmps
Step 5 copy running-config startup-config
To return the switch to its default setting, use the no vmps reconfirm global configuration command.

Changing the Retry Count

Beginning in privileged EXEC mode, follow these steps to change the number of times that the switch
attempts to contact the VMPS before querying the next server:
Command
Step 1 configure terminal
Step 2 vmps retry count
Step 3 end
Step 4
show vmps
Step 5 copy running-config startup-config
To return the switch to its default setting, use the no vmps retry global configuration command.
OL-9639-07
Purpose
Reconfirm dynamic-access port VLAN membership.
Verify the dynamic VLAN reconfirmation status.
Purpose
Enter global configuration mode.
Enter the number of minutes between reconfirmations of the dynamic
VLAN membership. The range is 1 to 120. The default is 60 minutes.
Return to privileged EXEC mode.
Verify the dynamic VLAN reconfirmation status in the Reconfirm Interval
field of the display.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Change the retry count. The retry range is 1 to 10; the default is 3.
Return to privileged EXEC mode.
Verify your entry in the Server Retry Count field of the display.
(Optional) Save your entries in the configuration file.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
Configuring VMPS
11-27