Cisco ME 3400 Software Configuration Manual page 499

Chapter 24 Configuring LLDP and LLDP-MED
Table 24-2
LLDP-MED TLV
network-policy
power-management
Beginning in privileged EXEC mode, follow these steps to disable a TLV on an interface:
Command
Step 1 configure terminal
Step 2
interface interface-id
Step 3
no lldp med-tlv-select tlv
Step 4 end
Step 5 copy running-config startup-config
Beginning in privileged EXEC mode, follow these steps to enable a TLV on an interface:
Command
Step 1 configure terminal
Step 2 interface interface-id
Step 3 lldp med-tlv-select tlv
Step 4
end
Step 5
copy running-config startup-config
This example shows how to enable a TLV on an interface when it has been disabled.
Switch# configure terminal
Switch(config)# interface GigabitEthernet1/0/1
Switch(config-if)# lldp med-tlv-select inventory-management
Switch(config-if)# end
OL-9639-07
LLDP-MED TLVs (continued)
Description
LLDP-MED network policy TLV
LLDP-MED power management TLV
Purpose
Enter global configuration mode.
Specify the interface on which you are configuring a LLDP-MED
TLV, and enter interface configuration mode.
Specify the TLV to disable.
Return to privileged EXEC mode.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Specify the interface on which you are configuring an LLDP-MED
TLV, and enter interface configuration mode.
Specify the TLV to enable.
Return to privileged EXEC mode.
(Optional) Save your entries in the configuration file.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
Configuring LLDP and LLDP-MED
24-7