Configuring Ethernet Cfm Crosscheck - Cisco ME 3400 Software Configuration Manual

Configuring Ethernet CFM
Command
Step 7
ethernet cfm mip level level-id
Step 8 ethernet cfm mep level level-id [inward] mpid
identifier vlan vlan-id
Step 9 exit
Step 10
snmp-server enable traps ethernet cfm cc [mep-up]
[mep-down] [config] [loop] [cross-connect]
Step 11
snmp-server enable traps ethernet cfm crosscheck
[mep-unknown] [mep-missing] [service-up]
Step 12
end
Step 13 show ethernet cfm {domain | maintenance-points} Verify the configuration.
Step 14 show running-config
Step 15
copy running-config startup-config
Use the no form of each command to remove a configuration or to return to the default settings.

Configuring Ethernet CFM Crosscheck

Beginning in privileged EXEC mode, follow these steps to configure Ethernet CFM crosscheck:
Command
Step 1 configure terminal
Step 2
ethernet cfm mep crosscheck start-delay delay
Step 3
ethernet cfm domain domain-name level level-id
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
41-8
Chapter 41 Configuring Ethernet OAM, CFM, and E-LMI
Purpose
Configure a customer level or service-provider level
maintenance intermediate point (MIP) for the interface.
The MIP level range is 0 to 7.
If you plan to configure a MEP at level 7 on this
Note
interface, do not use this command to configure a
MIP on the interface.
Configure maintenance end points (MEPs). for different
maintenance levels. The MEP level range is 0 to 7.
(Optional) Specify the end point in the inward
•
direction.
For mpid identifier, enter a maintenance end point
•
identifier. The identifier must be unique for each
VLAN (service instance). The range is 1 to 8191.
• For vlan vlan-id, enter the service provider VLAN ID
or IDs as a VLAN-ID (1 to 4095), a range of
VLAN-IDs separated by a hyphen, or a series of
VLAN IDs separated by comma.
Repeat the command for different level IDs.
Note
Return to global configuration mode.
(Optional) Enable Ethernet CFM continuity check traps.
(Optional) Enable Ethernet CFM crosscheck traps.
Return to privileged EXEC mode.
Verify your entries.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Configure the number of seconds that the device waits for
remote MEPs to come up before the crosscheck is started.
The range is 1 to 65535; the default is 30 seconds.
Define a CFM domain, set the domain level, and enter
ethernet-cfm configuration mode for the domain. The
maintenance level number range is 0 to 7.
OL-9639-07