Cisco ME 3400 Software Configuration Manual page 561

Chapter 29 Configuring SNMP
Table 29-5 Switch Notification Types (continued)
Notification Type Keyword
config
copy-config
cpu threshold
entity
envmon
ethernet
flash
hsrp
ipmulticast
mac-notification
msdp
ospf
pim
port-security
rtr
snmp
storm-control
stpx
syslog
tty
vlan-membership
vlancreate
vlandelete
OL-9639-07
Description
Generates a trap for SNMP configuration changes.
Generates a trap for SNMP copy configuration changes.
Generates a trap for CPU threshold violations.
Generates a trap for SNMP entity changes.
Generates environmental monitor traps. You can enable any or all of these environmental
traps: fan, shutdown, status, supply, temperature.
Generates an SNMP Ethernet trap.
Generates SNMP FLASH notifications.
Generates a trap for Hot Standby Router Protocol (HSRP) changes.
Generates a trap for IP multicast routing changes.
Generates a trap for MAC address notifications.
Generates a trap for Multicast Source Discovery Protocol (MSDP) changes.
Generates a trap for Open Shortest Path First (OSPF) changes. You can enable any or all of
these traps: Cisco specific, errors, link-state advertisement, rate limit, retransmit, and state
changes.
Generates a trap for Protocol-Independent Multicast (PIM) changes. You can enable any or
all of these traps: invalid PIM messages, neighbor changes, and rendezvous point
(RP)-mapping changes.
Generates SNMP port security traps. You can also set a maximum trap rate per second. The
range is from 0 to 1000; the default is 0, which means that there is no rate limit.
When you configure a trap by using the notification type port-security, configure the
Note
port security trap first, and then configure the port security trap rate:
snmp-server enable traps port-security
•
snmp-server enable traps port-security trap-rate rate
•
Generates a trap for the SNMP Response Time Reporter (RTR).
Generates a trap for SNMP-type notifications for authentication, cold start, warm start, link
up or link down.
Generates a trap for SNMP storm-control. You can also set a maximum trap rate per minute.
The range is from 0 to 1000; the default is 0 (no limit is imposed; a trap is sent at every
occurrence).
Generates SNMP STP Extended MIB traps.
Generates SNMP syslog traps.
Generates a trap for TCP connections. This trap is enabled by default.
Generates a trap for SNMP VLAN membership changes.
Generates SNMP VLAN created traps.
Generates SNMP VLAN deleted traps.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
Configuring SNMP
29-13