Cisco ME 3400 Software Configuration Manual page 879

Chapter 38 Configuring HSRP
Command
Step 5
standby [group-number] [priority
priority] preempt [delay delay]
Step 6 standby [group-number] track
type number [interface-priority]
Step 7
end
Step 8 show running-config
Step 9 copy running-config
startup-config
Use the no standby [group-number] priority priority [preempt [delay delay]] and no standby
[group-number] [priority priority] preempt [delay delay] interface configuration commands to restore
default priority, preempt, and delay values.
Use the no standby [group-number] track type number [interface-priority] interface configuration
command to remove the tracking.
This example activates a port, sets an IP address and a priority of 120 (higher than the default value),
and waits for 300 seconds (5 minutes) before attempting to become the active router:
Switch# configure terminal
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# no switchport
Switch(config-if)# standby ip 172.20.128.3
Switch(config-if)# standby priority 120 preempt delay 300
Switch(config-if)# end
OL-9639-07
Purpose
Configure the router to preempt, which means that when the local router has
a higher priority than the active router, it assumes control as the active router.
• (Optional) group-number—The group number to which the command
applies.
(Optional) priority—Enter to set or change the group priority. The range
•
is 1 to 255; the default is 100.
(Optional) delay—Set to cause the local router to postpone taking over the
•
active role for the number of seconds shown. The range is 0 to 3600
(1 hour); the default is 0 (no delay before taking over).
Use the no form of the command to restore the default values.
Configure an interface to track other interfaces so that if one of the other
interfaces goes down, the device's Hot Standby priority is lowered.
(Optional) group-number—The group number to which the command
•
applies.
type—Enter the interface type (combined with interface number) that is
•
tracked.
number—Enter the interface number (combined with interface type) that is
•
tracked.
(Optional) interface-priority—Enter the amount by which the hot standby
•
priority for the router is decremented or incremented when the interface
goes down or comes back up. The default value is 10.
Return to privileged EXEC mode.
Verify the configuration of the standby groups.
(Optional) Save your entries in the configuration file.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
Configuring HSRP
38-9