Configuring Ethernet Oam Link Monitoring - Cisco ME 3400 Software Configuration Manual

Setting Up and Configuring Ethernet OAM
Command
Step 3
ethernet oam remote-loopback {supported |
timeout seconds}
Step 4
end
Step 5 ethernet oam remote-loopback {start | stop}
{interface interface-id}
Step 6 show ethernet oam status [interface interface-id]
Step 7 copy running-config startup-config
Use the no ethernet oam remote-loopback {supported | timeout} interface configuration command to
disable remote loopback support or to remove the timeout setting.

Configuring Ethernet OAM Link Monitoring

You can configure high and low thresholds for link-monitoring features. If no high threshold is
configured, the default is none —no high threshold is set. If you do not set a low threshold, it defaults
to a value lower than the high threshold.
Beginning in privileged EXEC mode, follow these steps to configure Ethernet OAM link monitoring on
an interface:
Command
Step 1 configure terminal
Step 2
interface interface-id
Step 3
ethernet oam link-monitor supported
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
41-18
Chapter 41 Configuring Ethernet OAM, CFM, and E-LMI
Purpose
Enable Ethernet remote loopback on the interface, or set a
loopback timeout period.
• Enter supported to enable remote loopback.
• Enter timeout seconds to set a remote loopback
timeout period. The range is from 1 to 10 seconds.
Return to privileged EXEC mode.
Turn on or turn off Ethernet OAM remote loopback on an
interface.
Verify the configuration.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Define an interface, and enter interface configuration
mode.
Enable the interface to support link monitoring. This is the
default.
You need to enter this command only if it has been disabled
by previously entering the no ethernet oam link-monitor
supported command.
OL-9639-07