Cisco ME 3400 Software Configuration Manual page 199

Chapter 8 Configuring IEEE 802.1x Port-Based Authentication
Default IEEE 802.1x Configuration
Table 8-2
Table 8-2
Feature
AAA
RADIUS server
•
•
•
Switch IEEE 802.1x enable state
Per-port IEEE 802.1x enable state
Periodic re-authentication
Number of seconds between
re-authentication attempts
Re-authentication number
Quiet period
Retransmission time
Maximum retransmission number
Host mode
Client timeout period
Authentication server timeout period
OL-9639-07
shows the default IEEE 802.1x configuration.
Default IEEE 802.1x Configuration
IP address
UDP authentication port
Key
Default Setting
Disabled.
None specified.
•
1812.
•
None specified.
•
Disabled.
Disabled (force-authorized).
The port sends and receives normal traffic without IEEE
802.1x-based authentication of the client.
Disabled.
3600 seconds.
2 times (number of times that the switch restarts the
authentication process before the port changes to the
unauthorized state).
60 seconds (number of seconds that the switch remains in
the quiet state following a failed authentication exchange
with the client).
30 seconds (number of seconds that the switch should
wait for a response to an EAP request/identity frame
from the client before resending the request).
2 times (number of times that the switch will send an
EAP-request/identity frame before restarting the
authentication process).
Single-host mode.
30 seconds (when relaying a request from the
authentication server to the client, the amount of time the
switch waits for a response before resending the request
to the client.)
30 seconds (when relaying a response from the client to
the authentication server, the amount of time the switch
waits for a reply before resending the response to the
server.)
You can change this timeout period by using the dot1x
timeout server-timeout interface configuration
command.
Cisco ME 3400 Ethernet Access Switch Software Configuration Guide
Configuring IEEE 802.1x Authentication
8-11