Reconfirming Vlan Memberships; Changing The Reconfirmation Interval; Changing The Retry Count - Cisco 2950G 24 - Catalyst Switch Software Configuration Manual
Desktop switch
Hide thumbs
Also See for 2950G 24 - Catalyst Switch:
- Migration manual (25 pages) ,
- Datasheet (19 pages) ,
- Product support bulletin (5 pages)
Table of Contents
Advertisement
Configuring VMPS
Reconfirming VLAN Memberships
Beginning in privileged EXEC mode, follow these steps to confirm the dynamic port VLAN membership
assignments that the switch has received from the VMPS:
Command
Step 1
vmps reconfirm
Step 2
show vmps
Changing the Reconfirmation Interval
VMPS clients periodically reconfirm the VLAN membership information received from the VMPS. You
can set the number of minutes after which reconfirmation occurs.
If you are configuring a member switch in a cluster, this parameter must be equal to or greater than the
reconfirmation setting on the command switch. You must also first use the rcommand privileged EXEC
command to log into the member switch.
Beginning in privileged EXEC mode, follow these steps to change the reconfirmation interval:
Command
Step 1
configure terminal
Step 2
vmps reconfirm minutes
Step 3
end
Step 4
show vmps
Step 5
copy running-config startup-config
To return the switch to its default setting, use the no vmps reconfirm global configuration command.
Changing the Retry Count
Beginning in privileged EXEC mode, follow these steps to change the number of times that the switch
attempts to contact the VMPS before querying the next server:
Command
Step 1
configure terminal
Step 2
vmps retry count
Step 3
end
Step 4
show vmps
Step 5
copy running-config startup-config
Catalyst 2950 Desktop Switch Software Configuration Guide
14-30
Purpose
Reconfirm dynamic port VLAN membership.
Verify the dynamic VLAN reconfirmation status.
Purpose
Enter global configuration mode.
Enter the number of minutes between reconfirmations of the dynamic
VLAN membership.
Enter a number from 1 to 120. The default is 60 minutes.
Return to privileged EXEC mode.
Verify the dynamic VLAN reconfirmation status in the Reconfirm
Interval field of the display.
(Optional) Save your entries in the configuration file.
Purpose
Enter global configuration mode.
Change the retry count.
The retry range is from 1 to 10; the default is 3.
Return to privileged EXEC mode.
Verify your entry in the Server Retry Count field of the display.
(Optional) Save your entries in the configuration file.
Chapter 14
Configuring VLANs
78-14982-01
Advertisement
Table of Contents
Troubleshooting
