Setting For Measurement Of Characteristic Points - Omron ZS-HL User Manual

Section5

Setting for Measurement of Characteristic Points

Setting for Measurement of Characteristic Points
You can measure any measurement points within the range of received light by using the
line beam characteristics and multi-task function. Set this menu when you measure subtle
concavity and convexity in the workpiece or thickness of a transparent object.
The setting for measuring the characteristic points are valid only in Multi-Task mode.
FUN Mode-[MEASURE]-[Measured value]
Setting
NONE
AVERAGE
PEAK
BOTTOM
THICK
STEP
K+mX+nY(calculation)
ZS-HL
5-24
User's Manual
Does not set measurement points.
Measures the average position between the peak
and bottom positions of the line beam.
You can measure the distance from the work-
piece. (default value)
Measures the peak position of the line beam.
You can measure the highest position in the line
beam.
Measures the bottom position of the line beam.
You can measure the lowest position in the line
beam.
Measures the thickness of a transparent object
such as glass.
Measures between peak and bottom in the line
beam.
You can detect subtle concavity and convexity in
the workpiece.
Select this to perform logic operations on X and Y with the coefficient freely set. In
addition, you can assign, to TASK, the measurement of characteristic points you
have set, and measure multiple points or perform calculations.
• K range: -999999 to 999999
• m range: -10.0 to 10.0
• n range: -10.0 to 10.0
• X range: NONE, TASK1 to TASK4
• Y range: NONE, TASK1 to TASK4
Description
Line beam
Line beam
Line beam
Thickness
Line beam
Average
Peak
Bottom
Peak/bottom