Sensor Controller; Specifications - Omron ZS-HL User Manual

Section8

Sensor Controller

Sensor Controller

Specifications

I/O type
Average number of times
Number of connected Sensor Heads
Exter- Connection method
nal I/F
Serial
I/O
Output 3 judgment outputs:
Input
Status indicators
Segment dis-
play
LCD
Setting input
Power supply voltage
Current consumption
Insulation resistance
Dialectic strength
Degree of protection
Noise immunity
Vibration resistance (destructive)
Shock resistance (destructive)
ZS-HL
8-38
User's Manual
Item
NPN type
1, 2, 4, 8, 16, 32, 64, 128, 256, 512, 1024, 2048, or 4096
1 per Sensor Controller
Serial I/O is connector type.
Otherwise, prewired (standard cable length: 2 m)
USB2.0 1 port, FULL SPEED[12 Mbps], MINI-B
RS-232C 1 port, max. 115,200 bps
NPN open-collector, 30 VDC,
HIGH/PASS/LOW) 50 mA max. residual voltage;
1.2 V max.
Linear output Selectable from voltage/current
(selected by slide switch on base)
• At voltage output: -10 to +10 V, output impedance: 40
• At current output: 4 to 20 mA, max. load resistance: 300
LDOFF input (LD ON: Short-circuited with 0V ter-
forced OFF)
OFF: Open (leakage current:
Zero reset input (exe-
cute or cancel zero
reset)
Timing input (sample
cycle specified when
hold function is enabled)
Reset input (reset of
hold state)
HIGH (orange), PASS (green), LOW (orange),
LDON (green), ZERO (green), ENABLE (green)
Main display 8-segment red display, 6 digits
Sub-display 8-segment green display, 6 digits
16 digits × 2 rows, color of characters: green, resolution per charac-
ter: 5 × 8 pixel matrix
Setting keys Direction keys (UP/DOWN/LEFT/RIGHT), SET key, ESC key,
MENU key, function keys (1 to 4)
Slide switch Threshold switch (H/L 2-state)
Mode switch (FUN/TEACH/RUN 3-state)
21.6 V to 26.4 V (including ripple)
0.5 A max. (when Sensor Head is connected)
Across all lead wires and controller case: 20 M
Across all lead wires and controller case, 1000 VAC, 50/60 Hz, 1 min
IP20 (IEC60529)
1,500 V peak-to-peak, pulse width 0.1 µs/1 µs, rising edge: 1 ns
pulse
10 to 150 Hz, 0.7-mm double amplitude, 80 min each in X, Y, and Z
directions
300 m/s
backward)
ZS-HLDC11
minal or 1.5 V max.
0.1 mA max.)
2 3 times each in six directions (up/down, left/right, forward/
ZS-HLDC41
PNP type
PNPopen-collector
50 mA max. residual voltage;
1.2 V max.
Ω
Ω
ON: Supply voltage short-cir-
cuited or within supply volt-
age -1.5 V max.
OFF: Open (leakage current:
0.1 mA max.)
Ω
(by 250 V megger)