System Configuration - Omron ZS-HL User Manual

System Configuration

In addition to operations with the basic configuration, ZS-HLDC can support various
measurement applications when combined with numerous peripheral devices.
Basic configuration
Sensor Head
ZS-HLDS_ _ _/LD_ _
Detects a sensing object.
LD ON ZERO ENABLE
H
P
Sensor Controller
L
ZS-HLDC_ _
Performs measurements
and outputs the results.
(*1)
USB
(*1)
SmartMonitor ZS
(Setting support software for personal computers)
This setting support software sets
sensing conditions while monitoring
the receiving status, and allows a user
to check the measured value in a time
series graph.
: Accessory for the Sensor Controller ZS-HLDC_1A
*1
Power supply
DC24 V (±10 %)
Recommended part
(1) If the number of connections is
1: S82K-01524 (DC24 V, 0.6 A)
(2) If the number of connections is
2 to 3: S82K-05024 (DC24 V, 2.1 A)
(3) If the number of connections is
4 to 10: Prepare as many of the
above power supplies of (1) and
(2) as you need.
Personal computer
USB
RS-232C
ZS-XPT2
RS-232C
ZS-XPT2
Linear output
High-speed parallel
output
Real-time parallel
Output unit
ZS-RPD_1
Extension cable for Sensor Head
ZS-XC_A (1 m, 4 m, 8 m)
ZS-XC_ _B(5 m, 10 m): Up to two cables can be connected.
ZS-XC5BR (5 m): Up to two cables can be connected.
Robot cable type.
Long Extend the cable of Sensor Head
• Extension cable for a long
distance (*2)
ZS-XC_ _CR (15 m, 25 m)
Method of connecting
p.2-6
a cable
*2:
Only the ZS-HLDS@@@ Sensor Head can be connected to the ZS-XC@@CR,
ZS-XC02D, and ZS-XEQ.
Section 1

System Configuration

Peripheral devices
• Communication using commands
• Communication using SmartMonitor
ZS Professional
Programmable controller
• Communication using commands
Programmable terminal
RUN RUN
• Communication using NS SmartMonitor
Digital panel meter
• Compare waveforms and make a judgment
High-speed input board (personal computer)
• Obtain measurement data quickly
• Digital equalizer
connection cable
ZS-XC02D (*2)
• Digital equalizer ZS-XEQ (*2)
ZS-HL
User's Manual
1-3