Table of Contents
Advertisement
When a zero reset is executed, the linear output becomes the voltage (or current) value at the cen-
ter of the two preset points. Linear output becomes roughly 0V (12 mA) when focus is not set.
■ TYPE
Set how zero reset is to be executed.
FUN Mode-[OUTPUT]-[0 RESET]-[TYPE]
Setting
REAL
HOLD
■ Offset
Set an offset to set the reference value for zero reset to a value other than 0.
FUN Mode-[OUTPUT]-[0 RESET]-[OFFSET]
Setting
OFFSET
Setting Output Processing of Sensing Information
Sets the measured value when a zero reset is executed to zero. (default value)
Zero reset
Sets the measured value (hold value) when a zero reset is executed to zero.
This setting is enabled when hold measurement is performed.
Zero reset
Sets the reference value.
Range: -999.99 to 999.999 (default value: 0)
Description
Measurement of height
from reference surface
Reference A
Hold A
Measurement of height
(reference)
from reference surface
Direction of movement
Description
Section 3
ZS-L
3-29
User's Manual
Advertisement
Table of Contents
