Section 1
Part Names and Functions
Part Names and Functions
The following describes the names and functions of parts on the Sensor Controller and
Sensor Head.
■ Sensor Controller
(12) HIGH indicator
(11) PASS indicator
(10) LOW indicator
(9) Threshold switch
(1) Laser indicator
The Laser indicator is lit while the Sensor Head is emitting a laser beam.
(2) Zero Reset indicator
The Zero Reset indicator is lit when the zero reset function is enabled.
(3) ENABLE indicator
The ENABLE indicator lights when the Sensor is ready for measurement. It goes off
when measurement is not possible (e.g. when the received light amount is excessive or
insufficient, when the measuring range is exceeded, when the Sensor Head is not con-
nected, or when measurement is not being performed in the FUN mode).
(4) Main Display
The Main Display shows measured values.
(5) Sub-display
The sub-display shows thresholds and additional information during measurement.
ZS-L
1-10
User's Manual
LD ON ZERO ENABLE
H
P
L
(18) USB port
(13) Sensor Head connector
(1) Laser indicator
(2) Zero Reset indicator
(3) ENABLE indicator
(4) Main display
(5) Sub-display
(6) LCD screen
(7) Control keys
(8) Mode switch
(15) RS-232C connector
(16) Voltage/current switch
(17) I/O cable
(14) Coupler