Table of Contents
Advertisement
2.
Place the sensing object at the position (second
point) to perform scaling, and enter the desired
offset value (second point).
Press the LEFT key. The sub-display blinks.
3.
Press the SET key to apply the setting.
■ Manual Setting
Enter numerical values for scaling correction values.
FUN Mode-[OUTPUT]-[SCALING]-[ON]-[MANUAL]
Setting
SPAN
OFFSET
Setting Output Processing of Sensing Information
Sets the inclination of the sensor characters as a coefficient.
Range:-2.0 to 2.0
Measurement value
(mm)
2.0
-2.0
Adds/subtracts a fixed value to or from the measured value.
Range: -999.99 to 999.999
Measurement value
(mm)
INPUT POINT 2
DIG
VAL SET:OK
Description
Workpiece
displacement
Workpiece
displacement
Section 3
ZS-L
3-23
User's Manual
Advertisement
Table of Contents
