Table of Contents
Advertisement
(6) LCD screen
RUN Mode
:Displays additional information for the main display and the setup menu
for display related information.
TEACH Mode:Displays the menu for setting up the thresholds.
FUN Mode
:Displays the measurement condition setup menu.
(7) Control keys
The Control Keys are for setting measurement conditions and other information. The
functions assigned to the Control Keys change according to the operating mode.
Displays and Key Operations p.3-5
(8) Mode Switch
The Mode Switch selects the operating mode.
RUN mode
: Select this mode when performing regular measurement.
TEACH mode : Select this mode when setting the judgment thresholds.
FUN mode
: Select this mode when setting measurement conditions.
(9) Threshold Selector Switch
The Threshold Selector switch selects whether to set (or display) the HIGH or LOW
threshold.
(10) LOW indicator
The LOW indicator is lit when the condition "measured value < LOW threshold" is satis-
fied.
(11) PASS indicator
The PASS indicator is lit when the condition "LOW threshold ≤ measured value ≤ HIGH
threshold" is satisfied.
(12) HIGH indicator
The HIGH indicator is lit when the condition "HIGH threshold < measured value" is sat-
isfied.
(13) Sensor Head connector
This connector connects the Sensor Head.
(14) Coupler
This connector is used to connect two or more Sensor Controllers. It is located on both
sides of the Sensor Controller.
(15) RS-232C connector
Connect the RS-232 cable when you are connecting the Sensor Controller to a per-
sonal computer that does not have a USB port.
(16) Voltage/Current switch
The Voltage/Current switch selects between voltage output and current output.
Before operating this switch, make sure that the Sensor Controller is turned OFF. Also, make sure
that the load connected to "linear output wire (co-axial) – linear GND wire" satisfies the rating of the
set state (voltage or current output) before turning the Sensor Controller ON. Otherwise, the Sensor
Controller may be damaged.
Rating of connected load (I/O Circuit Diagrams) p.2-9
Section 1
Part Names and Functions
User's Manual
ZS-L
1-11
Advertisement
Table of Contents
