Table of Contents
Advertisement
Section 1
Part Names and Functions
(17) I/O Cable
The I/O cable connects the Sensor Controller to the power supply and external
devices, such as timing sensors or programmable controllers.
(18) USB port
Connect the USB cable to the USB port to connect to a personal computer.
■ Sensor Head
(1) Laser emitter/
receiver section
(1) Laser Emitter/Receiver Section
This is the section that emits the laser beam and receives reflected light.
(2) Connector
To be connected to the Sensor Controller
(3) FAR indicator, (4) NEAR indicator
These indicators lit as follows according to the distance between the front of the Sensor
Head and workpiece.
Both NEAR and FAR indicators are lit : Measuring center distance ±
NEAR indicator is lit
FAR indicator is lit
NEAR and FAR indicators are flashing : Outside measuring range
These indicators also function as laser alarm indicators.
• At least either of these indicator lights or flashes after the Sensor Head is turned ON.
• Both indicators go out for 15 to 25 seconds after the Sensor Head is turned ON to indicate that the
• Either of these indicators lit or flashes while the laser beam is being emitted.
• Both indicators go out when the laser beam is OFF.
ZS-L
1-12
User's Manual
(2) Connector
laser beam is OFF.
(measuring range x 10%)
: Near side within measuring range
: Far side within measuring range
(3) FAR indicator
(4) NEAR indicator
Advertisement
Table of Contents
