Command Reference: Function Blocks
Timing Chart
Input
Set Value
Timer Value
0
Output
Enable
8-5-8
ON-delay Timer
Diagram
General Description
Set Parameters
Timing Chart
Input
Set value
Timer value
0
Output
Enable
Idle to RUN
The ON-delay Timer function block performs a timer operation for an ON
delay set in 10-ms increments. The range for this delay is from 0 ms to 300 s.
Parameter
Delay Time
0 to 300 s in 10-ms increments
The delay time must be equal to or greater than the NE1A-series Controller's
cycle time.
Idle to RUN
Setting range
Section 8-5
Default setting
0 ms
173