Frequency Reference Selection; Run Command Selection - Omron JX User Manual

4-2 Function Mode
<Group A: Standard Function Parameter>

Frequency Reference Selection

Select the method of the frequency reference.
Parameter No.
A001
*
A201
4
Related parameters
* To switch to the 2nd frequency reference, allocate 08 (SET) to the multi-function input terminal and then turn it
on.

RUN Command Selection

Select the method of the RUN/STOP command.
Parameter No.
A002
*
A202
Related parameters
* To switch to the 2nd RUN command, allocate 08 (SET) to the multi-function input terminal and then turn it on.
Data
01
02
03
4-8
Function name
Frequency reference 00: Digital Operator (FREQ adjuster)
selection 01: Terminal
02: Digital Operator (F001)
2nd frequency
03: ModBus communication
reference selection
10: Frequency operation result
Data
00 FREQ adjuster
01 Voltage or current setpoint reference from the terminal.
02 F001 value set via the Digital Operator.
03 ModBus communication
10 Result of the frequency operation function
Function name
RUN command
01: Terminal
selection
02: Digital Operator
2nd RUN command
03: ModBus communication
selection
Turn ON/OFF by FW and RV allocated to the terminal.
The STOP command is activated if both Forward/Reverse commands are input
simultaneously.
Use the RUN and STOP/RESET keys on the Digital Operator.
Use the ModBus communication.
Data
A005, A141 to A143, A145, A146
Frequency reference source
Data
F004, A005, C001 to C005
RUN command source
Default setting Unit
⎯
00
Default setting Unit
⎯
02