Automatically Setting Data Links - Omron CS1W-SLK11-21 - 06-2004 Manual

Data Link Procedures
1-5-2

Automatically Setting Data Links

1,2,3...
12
8. Start the data links.
Contents
Start the data links.
Note (a) Data link Start/Stop Bit (N= unit number):
CS Series: Word 0 of DM30000 + 100 × N
(b) The data links will not start if there is an error in the data link ta-
bles in the startup node.
9. Stop the data links.
Contents
Stop the data links.
Note Data link Start/Stop Bit (N= unit number):
CS Series: Word 0 of DM30000 + 100 × N
Data link tables can be automatically created by setting the data link mode to
automatic data link table creation. Use the following procedure.
1. Install and wire the Units.
Contents
a. Mount the Units to
the PLCs.
b. Wire the Network.
c. Connect terminat-
ing resistance
2. Prepare for communications.
Contents
a. Set the unit num-
ber.
b. Set the node
address.
3. Turn ON the power to the PLC.
Contents
Turn ON the power to
the PLC.
Method
Switch the Data link Data link startup node
Start/Stop Bit (see
(The Start Bit can be
below) from OFF to
turned ON in more
ON using either the
then one node to
Programming Device,
make sure the data
the user program, the
links start even when
CX-Net within the CX-
the startup node is
Programmer.
down.)
Method
Switch the Data link Any node that is active
Start/Stop Bit (listed in the data link
below) from OFF to
ON using either the
Programming Device,
the user program, the
CX-Net within the CX-
Programmer.
Method
--- All nodes
--- All nodes
Use C100H-TER01 Coaxial systems only.
Terminator.
End nodes on the net-
work: Connect Termi-
nator
Method
Use the front rotary CS-series, CVM1, and
switches. CV-series PLCs only
Use the front rotary All nodes
switches.
Method
--- All nodes
Section 1-5
Nodes Page
55, 67
Nodes Page
55, 67
Nodes Page
18
19
Nodes Page
18
Nodes Page
---