Omron CS1W-SLK11-21 - 06-2004 Manual page 28

Data Link Procedures
3. Turn ON the power to the PLC.
Contents
Turn ON the power to
the PLC.
4. Connect the Programming Device.
Contents
Connect the Program-
ming Console or Sup-
port Software.
5. Create I/O tables.
Contents
Input the I/O tables.
6. Set the data link mode.
Contents
Set data link mode to
manual.
Note Be sure that the data link mode in the data link parameters in the DM
Area is set to 00 when using manually set data links.
7. Register the data link tables by making the following settings for each
node.
Contents
First data link status word
Data link nodes
Area First data link sta-
1 tus words
Numbers of data
link words
Area First data link sta-
2 tus words
Numbers of data
link words
Note Offsets are used to control where data is placed within the receive ar-
ea.
Method
--- All nodes
Method
Use the special con- CS-series, CVM1, and
nection cable. CV-series PLCs
Method
Use the SYSMAC CS-series, CVM1, and
Support Software or CV-series PLCs only
Programming Con-
sole.
Method
Use the SYSMAC Data link startup node
Support Software or only
Programming Con-
The node that is used
sole.
to start the data link is
called the startup
node. It is necessary
to decide beforehand
which node will be the
startup node.
Method
Use the CX-Net All nodes within the
within the CX-Pro- network
grammer.
Delete from the data
link tables all nodes
that are not in a data
link.
Section 1-5
Nodes Page
---
Nodes Page
8
Nodes Page
---
Nodes Page
45
Nodes Page
46, 67
11