Fins Commands For Sysmac Link Units; Response Codes - Omron CS1W-SLK11-21 - 06-2004 Manual

FINS Command/Response Format
6-3-5

FINS Commands for SYSMAC LINK Units

6-3-6

Response Codes

Command
code
04 01 DATA LINK START (see note)
02 DATA LINK HALT (see note)
03 RESET
05 01 CONTROLLER DATA READ (see note)
06 01 CONTROLLER STATUS READ (see note)
02 NETWORK STATUS READ
03 DATA LINK STATUS READ
08 01 INTERNODE ECHO TEST
02 BROADCAST TEST RESULTS READ
03 BROADCAST TEST DATA SEND
21 02 ERROR LOG READ (see note)
03 ERROR LOG CLEAR (see note)
Note These commands can also be sent to the PLC.
A response code consists of two bytes. If a command is completed normally, a
response code of 00 00 will be returned. The first two digits of a response
code are called the main response code (MRES) and the last two digits are
called the sub-response code (SRES). If command execution results in an
error, one of the response codes listed in the following table will be returned.
Refer to 8-1-2 Probable Causes and Remedies of Response Code Errors for
details.
MRES
00 Normal completion
01 Local node error
02 Destination node error
03 Controller error
04 Not executable
05 Routing error
10 Command format error
11 Parameter error
20 Read not possible
21 Write not possible
22 Not executable in current PLC mode
23 No Unit
24 Start/Stop not possible
25 Unit error
26 Command error
30 Access right error
Name
Description
Section 6-3
Page
112
112
112
113
113
115
117
118
119
119
120
121
111