Omron CS1W-SLK11-21 - 06-2004 Manual page 40

Cable Connections
6. Using your fingertips, press down on B on the trimming tool blade, forcing
the blade into the polyethylene, and twist several times. Continuing to
press down on B, withdraw in the direction of arrow D as shown below.
7. Use scissors to cut off any protruding braiding as shown below.
8. Insert the contact into the contact crimp adapter, and set them inside the
crimp tool die. Insert the cable central conductor into the contact hole until
the severed face of the polyethylene meets the contact guard. Firmly grasp
the crimp tool handle and crimp.
9. Insert the completed contact subassembly into the body. Gently rotate and
press until the contact wings enter the insulator cavity, and align the con-
tact tip with the insulator tip. After inserting the contact wings into the cav-
ity, rotate the cable and the body until the body is crimped.
Contact
subassembly
Section 2-4
B
D
Conductor
Body
Insulator
23