Omron CS1W-SLK11-21 - 06-2004 Manual page 97

CX-Programmer Procedures
The data link parameters (Common Link
Parameters and Refresh Parameters) will
be displayed when the data link tables are
read.
Click the Write button to transfer the
data link tables to the PLCs. Refer to
Data Link Setup (SYSMAC LINK) Dia-
log Box Functions below for other but-
ton functions.
Transferring Data Link Tables
1,2,3...
Note
Data Link Setup SYSMAC
LINK Dialog Box
Functions
80
3. Click the Open button. The Open Dialog Box will appear.
4. Select the data link tables file (Sample.sl3), and then click the Open but-
ton. The data link tables will be read as follows:
1. Select the destination PLC node address in the Nodes Field under Com-
mon Link, or select the Operate on all Nodes in Network Checkbox. If
Operate on all Nodes in Network is selected, you can transfer data link
tables simultaneously to all PLCs.
2. Click the Write button.
• Data link tables will start to be transferred to the nodes set in the
Nodes Field, or to all the nodes on the same network.
• When the transfer is finished, the bottom of the window will be dis-
played as follows:
If directly connected online with a PLC for which the routing tables have not
been set, data link tables cannot be transferred to PLCs that are not directly
connected to the network. Perform one of the following to transfer data link
tables to PLCs on the network.
• Directly connect to a PLC in which the routing tables have been set and
transfer the data link tables.
• Connect online to a PLC on the network, and transfer the data link tables.
The following table displays the functions of the Data Link Setup (SYSMAC
LINK) Dialog Box.
Button name
Close Closes the dialog box.
New Clears the data link table currently in operation.
Open Reads the data link tables file (*.sl3).
Info Used to display and enter the name of the creator, file title, com-
ments, etc.
Save as Used to save the edited data link tables (*.sl3).
Section 4-12
Function