4-10 Creating And Editing I/O Comments; Setting/Canceling Explicit Message Communications; Starting Remote I/O Communications - Omron 3G8F5-DRM21-E - V2 Operation Manual

Creating and Editing I/O Comments
4-9-5

Setting/Canceling Explicit Message Communications

Device - Parameter - Edit - General Tab - Explicit Message Communications Box
4-9-6

Starting Remote I/O Communications

Device - Parameter - Edit - General Tab - Start Remote I/O Communication at Start-Up Box

4-10 Creating and Editing I/O Comments

Device - Edit I/O Comment
1,2,3...
96
Note This procedure is supported for the CVM1-DRM21-V1 and
C200HW-DRM21-V1 only.
Specify whether or not to enable explicit message communications (transmis-
sions only) without remote I/O communications. Check the box to enable
explicit message communications only.
Note For the CS1W-DRM21 and CJ1W-DRM21, slaves with explicit message com-
munications only do not have to be registered. Explicit message communica-
tions is possible regardless of the scan list registration.
Note This procedure is supported for the CVM1-DRM21-V1 and
C200HW-DRM21-V1 only.
Specify whether or not to enable remote I/O communications automatically.
Check the box to start remote I/O communications automatically when the
master is started.
Note For the CS1W-DRM21 and CJ1W-DRM21, remote I/O communications upon
start-up can be disabled by disabling the master function.
Select Device, then select the Unit Function Tab of the Property Window,
and remove the check mark from Enable Master Function.
The Configurator can be used to add comments to I/O data of slaves.
The I/O comments can be checked while making I/O allocations to the master.
Note No I/O comments can be created or edited for a device if the device
is not designed to have I/O data.
To edit I/O comments, use the following procedures.
1. Select the device.
2. Select Device and Edit I/O Comment (or select the slave, click the right
mouse button, and select Edit I/O Comment).
Section 4-10