Adding Slaves - Omron 3G8F5-DRM21-E - V2 Operation Manual

Adding Slaves to the Master
4-3-2

Adding Slaves

Dragging and Dropping
Clicking the Right Mouse
Button and Selecting
Register to other Device
1,2,3...
70
The following three methods are supported for adding slaves.
Select the slave from the Network Configuration Window on the right and drag
and drop it on the master icon.
When slaves are registered with the master, I/O words will be automatically
allocated to the slaves in the order they are registered.
Drag and drop the slave icon on
the master icon.
After Registration
Master Node Address Displayed after Registration
When the slaves are registered, the master's node address will be
displayed (00 in the above case) with the prefix # after the symbol
A slave can also be added by selecting the slave in the Network Configuration
Window, clicking the right mouse button, selecting Register to other Device
or selecting Register to other Device from the Device Menu, and then
selecting the master from the menu. The menu will appear on the right-hand
side.
At the time of I/O allocation, the registered slave can be deleted or settings
can be made for the registered slave by using the Parameter Wizard or by
editing the parameters of the master.
Note To select a device from the menu and register it, use the following procedure.
1. Select the device.
2. Select Device.
3. Select Register to other Device.
When the slave is registered with the master,
the master's node address will be displayed
Section 4-3
.