Designating The Interface - Omron 3G8F5-DRM21-E - V2 Operation Manual

Connecting to the Network
3-3-2

Designating the Interface

1,2,3...
3. Connection can be made from the Ethernet port of the computer via a CS/
CJ-series Ethernet Unit. In this case also, a CS/CJ-series DeviceNet Unit
(CS1W-DRM21 or CJ1W-DRM21) is necessary for connection to the De-
viceNet network.
WS02-CFDC1-E
Configurator
Ethernet port
If the Configurator is Ver. 2.11 or later, it is possible to connect to the De-
viceNet network across (up to three) network levels via Ethernet, as shown
below.
WS02-CFDC1-E
Configurator
Ethernet network
CS/CJ-series
Ethernet Unit
Across network levels
Use the following procedure to designate the interface.
Note The interface is designated together with online connection settings.
1. Select Select Interface from the Option Menu.
(The interface presently selected is indicated with a check mark.)
2. Select the interface from those displayed on the menu.
• Select DeviceNet IF Card if a dedicated Board or Card is used.
• Select SYSMAC CS1 IF Port for a serial port connection.
• Select SYSMAC CS/CJ Ethernet Unit IF for an Ethernet connection.
Note The interface cannot be changed when the Configurator is online.
Select Network and Cancel Connection first. Then select the inter-
face offline.
3. Select Network and Connection from the menu bar.
The window corresponding to the designated interface will be displayed.
CS/CJ-series
Ethernet Unit
Ethernet network
Controller Link Unit
CS/CJ-series DeviceNet Unit
Controller Link Unit
CPU Unit
Controller Link network
Section 3-3
CS/CJ-series
DeviceNet Unit
CPU Unit
DeviceNet network
DeviceNet network
47