Error History Information - Omron 3G8F5-DRM21-E - V2 Operation Manual

The following table shows error information recorded in the DeviceNet Master Unit or DeviceNet Unit and mes-
sages that are displayed by selecting Device Monitor and Error History Display in the DeviceNet Configura-
tor.
CVM1-DRM21-V1 and C200HW-DRM21-V1
Error Error details
code
Upper 2
(Hex)
digits
0002 Code from Error node
7-segment address
0006
display on
Unit
000B
0101 Destination Frame
node address discriminator
(automatically
set by system
0103
when FINS
command is
set)
0109
0112
0117 Source node
address
0118
0119 Destination
node address
Appendix C

Error History Information

Error
Lower 2
digits
PLC interface error
Initialization error with PLC
Routing table error
Send
response
message
destroyed
Receive
response
message
destroyed
Send
response
message
destroyed
Error occurred in PLC interface.
Error occurred in initialization with
PLC.
Error in routing table data.
Not in network The local node is not in network;
attempted to send response mes-
sage, but message was destroyed.
Local node not Send error occurred; attempted to
participating send response message, but
message was destroyed.
Remote node Remote mode was busy; attempted
busy to send response message, but
message was destroyed.
Illegal header An illegal header was detected;
attempted to send response mes-
sage, but message was destroyed.
Reception The internal reception buffer in the
buffer full local node was full; attempted to
receive response message,
but message was destroyed.
Illegal An illegal message was received and
message destroyed.
Local node Local node was busy; attempted to
busy send response message, but mes-
sage was destroyed.
Meaning
segment
display
on Unit
F6
F5
E5
---
---
---
---
---
---
---
7-
149