Omron 3G8F5-DRM21-E - V2 Operation Manual page 50

PCMCIA Card Installation
The Remove selection is used to delete the selected driver.
Note a) The card name that is displayed first depends on the operating en-
vironment.
b) The card name registered here will be used on the Configurator to
access the ISA Board or PCMCIA Card.
c) Register a name for each ISA Board and PCMCIA Card.
11. Set the I/O port address, memory address, and interrupt (IRQ) for the ISA
Board or PCMCIA Card being used with the Configurator. (Refer to the
screen in step 12. )
12. Input the values that were confirmed in the PCMCIA Card setup for the I/
O Port, Memory Address, and Interrupt (IRQ).
Select -V1 Type in the Card Setup Dialog Box shown below when using the
3G8E2-DRM21-EV1.
The Card Name and Driver Name can be changed if necessary.
Make sure that all of the settings are correct and click the OK Button. The
Configuration Window shown in step 10 will be displayed.
Note The Configurator does not use interrupts. Set the interrupt level to
None.
Section 2-3
31