Replace an Intuvo Inlet Chip
Guard chip
Clips
Intuvo gasket
Detector chip
Figure 13 Intuvo bus components
WA RNING
Maintaining Your GC
Figure 13
shows the Intuvo major bus components.
The inlet and detector flow chips (see
installed before installing a column or detector tail.
1
Gather the following materials:
•
Intuvo inlet chip
•
7/16-inch open-end wrench
•
New Guard chip or jumper chip
•
Intuvo torque driver
The inlet, detector, bus, oven, and other accessories can be hot
enough to cause burns. Cool heated zones to a safe handling
temperature before continuing. If needed wear heat-resistant
gloves.
Maintaining Columns and Bus Components
Figure
13) must be
2
Smart ID key
connectors:
Inlet
Detector
Inlet chip
Intuvo gasket
49