C
H A P T E R
Use these commands to copy a traffic flow for one or more ports to a monitor port so that you
can examine the traffic on the monitor port without interference.
Use the running configuration commands to look at the current mirror settings.
See
Chapter 51 on page
mirror-filter commands are not supported on all Switch models.
35.1 Command Summary
The following section lists the commands for this feature.
Table 82 mirror Command Summary
COMMAND
mirror-port
mirror-port <port-num>
no mirror-port
interface port-channel <port-
list>
mirror
mirror dir
<ingress|egress|both>
no mirror
Ethernet Switch CLI Reference Guide
Mirror Commands
167.
DESCRIPTION
Enables port mirroring on the Switch.
Specifies the monitor port (the port to which traffic flow is
copied) for port mirroring.
Disables port mirroring on the Switch.
Enters config-interface mode for the specified port(s).
Enables port mirroring in the interface.
Enables port mirroring for incoming (ingress), outgoing
(egress) or both incoming and outgoing (both) traffic.
Disables port mirroring on the port(s).
35
M
P
C
13
C
13
C
13
C
13
C
13
C
13
C
13
123