C
H A P T E R
Use these commands to configure the management port IP address, default domain name
server and to look at IP domains.
See
Chapter 55 on page 179
See
Chapter 27 on page 107
26.1 Command Summary
The following section lists the commands for this feature.
Table 66 ip Command Summary
COMMAND
show ip
ip name-server <ip>
ip address <ip> <mask>
ip address default-gateway <ip>
show ip iptable all [IP|VID|PORT]
show ip iptable count
show ip iptable static
Table 67 tcp and udp Command Summary
COMMAND
show ip tcp
Ethernet Switch CLI Reference Guide
IP Commands
for static route commands.
for IP source binding commands.
DESCRIPTION
Displays current IP interfaces.
Sets the IP address of the domain name
server.
Sets the IP address of the MGMT port (for
out-of-band management) on the Switch.
Sets the default gateway for the out-of-
band management interface on the Switch.
Displays the IP address table. You can sort
the table based on the IP address, VLAN
ID or the port number.
Displays the number of IP interfaces
configured on the Switch.
Displays the static IP address table.
DESCRIPTION
Displays IP TCP information.
26
M
P
E
0
C
13
E
0
C
13
E
3
E
3
E
3
M
P
E
3
103