Vrrp Commands - ZyXEL Communications Dimension GS-3012 Cli Reference Manual

C
H A P T E R
This chapter explains how to use commands to configure the Virtual Router Redundancy
Protocol (VRRP) on the Switch.
67.1 VRRP Overview
VRRP is a protocol that allows you to configure redundant router connections. The protocol
reduces downtime in case of a single link failure. Multiple routers are connected and one is
elected as the master router. If the master router fails, then one of the backup routers takes over
the routing function within a routing domain.
67.2 Command Summary
The following section lists the commands for this feature.
Table 140 VRRP Command Summary
COMMAND
router vrrp network <ip-address>/<mask-bits>
vr-id <1~7> uplink-gateway <ip-address>
name <name>
priority <1~254>
interval <1~255>
primary-virtual-ip <ip-address>
no primary-virtual-ip <ip-address>
secondary-virtual-ip <ip-address>
no secondary-virtual-ip
no primary-virtual-ip
inactive
no inactive
Ethernet Switch CLI Reference Guide

VRRP Commands

DESCRIPTION
Adds a new VRRP network and enters the
VRRP configuration mode.
Sets a descriptive name of the VRRP
setting for identification purposes.
Sets the priority of the uplink-gateway.
Sets the time interval (in seconds) between
Hello message transmissions.
Sets the primary VRRP virtual gateway IP
address.
Resets the primary VRRP virtual gateway
IP address.
Sets the secondary VRRP virtual gateway
IP address.
Sets the network to use the default
secondary virtual gateway (0.0.0.0).
Resets the network to use the default
primary virtual gateway (interface IP
address).
Disables the VRRP settings.
Activates this VRRP.
67
M P
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
C 13
211