Command Modes - ZyXEL Communications Dimension GS-3012 Cli Reference Manual

<password> consists of 1-32 alphanumeric characters. For example, the following
command sets the password for privilege level 13 to pswd13. See
more information about this command.
sysname(config)# password pswd13 privilege 13
2.1.3.3 disable Command
This command reduces the session's privilege level to 0. It also changes the session to user
mode. This command is available in enable mode.

2.2 Command Modes

The CLI is divided into several modes. If a user has enough privilege to run a particular
command, the user has to run the command in the correct mode. The modes that are available
depend on the session's privilege level.
2.2.1 Command Modes for Privilege Levels 0-12
If the session's privilege level is 0-12, the user and all of the allowed commands are in user
mode. Users do not have to change modes to run any allowed commands.
2.2.2 Command Modes for Privilege Levels 13-14
If the session's privilege level is 13-14, the allowed commands are in one of several modes.
Table 7 Command Modes for Privilege Levels 13-14 and the Types of Commands in Each One
MODE PROMPT
enable
sysname#
config
sysname(config)#
config-interface
sysname(config-interface)#
config-interface
sysname(config-interface)#
config-mvr
sysname(config-mvr)#
config-route-
sysname(config-if)#
domain
config-dvmrp
sysname(config-dvmrp)#
config-igmp
sysname(config-igmp)#
config-ospf
sysname(config-ospf)#
config-rip
sysname(config-rip)#
config-vrrp
sysname(config-vrrp)#
Ethernet Switch CLI Reference Guide
Chapter 2 Privilege Level and Command Mode
COMMAND FUNCTIONS IN THIS MODE
Display current configuration, diagnostics, maintenance.
Configure features other than those below.
Configure ports.
Configure ports.
Configure multicast VLAN.
Enable and enter configuration mode for an IP routing
domain.
Configure Distance Vector Multicast Routing Protocol
(DVRMP).
Configure Internet Group Management Protocol (IGMP).
Configure Open Shortest Path First (OSPF) protocol.
Configure Routing Information Protocol (RIP).
Configure Virtual Router Redundancy Protocol (VRRP).
Chapter 68 on page 215 for
17