Broadcast Storm Commands - ZyXEL Communications Dimension GS-3012 Cli Reference Manual

C
H A P T E R

Broadcast Storm Commands

Use these commands to limit the number of broadcast, multicast and destination lookup failure
(DLF) packets the Switch receives per second on the ports.
Broadcast storm control implementation differs across Switch models.
• Some models use a single command (bmstorm-limit) to control the combined rate of
broadcast, multicast and DLF packets accepted on Switch ports.
• Other models use three separate commands (broadcast-limit, multicast-
limit, dlf-limit) to control the number of individual types of packets accepted on
Switch ports.
See Section 8.2 on page 42
8.1 Command Summary
The following table describes user-input values available in multiple commands for this
feature.
Table 23 User-input Values: broadcast-limit, multicast-limit & dlf-limit
COMMAND
pkt/s
The following section lists the commands for this feature.
Table 24 Command Summary: storm-control, bmstorm-limit, and bstorm-control
COMMAND
show interfaces config <port-
list> bstorm-control
storm-control
no storm-control
interface port-channel <port-
list>
bmstorm-limit
Ethernet Switch CLI Reference Guide
and Section 8.3 on page 42
DESCRIPTION
Specifies the maximum number of packets per second accepted by a Switch
port.
DESCRIPTION
Displays the current settings for broadcast storm control.
Enables broadcast storm control on the Switch.
Disables broadcast storm control on the Switch.
Enters subcommand mode for configuring the specified ports. C
Enables broadcast storm control on the specified port(s).
8
for examples.
M P
E 3
C 13
C 13
13
C 13
41