Igmp Filtering Commands - ZyXEL Communications Dimension GS-3012 Cli Reference Manual

C
H A P T E R

IGMP Filtering Commands

Use these commands to configure IGMP filters and IGMP filtering on the Switch.
23.1 Command Summary
The following section lists the commands for this feature.
Table 62 igmp-filtering Command Summary
COMMAND
show igmp-filtering profile
igmp-filtering
no igmp-filtering
igmp-filtering profile <name>
start-address <ip> end-address
<ip>
no igmp-filtering profile <name> Removes the specified IGMP filtering profile. You cannot
no igmp-filtering profile <name>
start-address <ip> end-address
<ip>
show interfaces config <port-
list> igmp-filtering
interface port-channel <port-
list>
igmp-filtering profile
<name>
no igmp-filtering profile
Ethernet Switch CLI Reference Guide
DESCRIPTION
Displays IGMP filtering profile settings.
Enables IGMP filtering on the Switch. Ports can only join
multicast groups specified in their IGMP filtering profile.
Disables IGMP filtering on the Switch.
Sets the range of multicast address(es) in a profile.
name: 1-32 alphanumeric characters
delete an IGMP filtering profile that is assigned to any ports.
Clears the specified rule of the specified IGMP filtering profile. C
Displays IGMP filtering settings.
Enters config-interface mode for the specified port(s).
Assigns the specified IGMP filtering profile to the port(s). If
IGMP filtering is enabled on the Switch, the port(s) can only
join the multicast groups in the specified profile.
Prohibits the port(s) from joining any multicast groups if IGMP
filtering is enabled on the Switch.
23
M P
E 3
C 13
C 13
C 13
C 13
13
E 3
C 13
C 13
C 13
95