Classifier Commands - ZyXEL Communications Dimension GS-3012 Cli Reference Manual

C
H A P T E R
Use these commands to classify packets into traffic flows. After classifying traffic, policy
commands (Chapter 43 on page
requested treatment in the network.
9.1 Command Summary
The following section lists the commands for this feature.
Table 25 Command Summary: classifier
COMMAND
name
show classifier [<
classifier <name> <[packet-
format <802.3untag|802.3tag|
EtherIIuntag| EtherIItag>]
[priority <0-7>] [vlan <vlan-
id>][ethernet-type <ether-
num|ip|ipx|arp|rarp|
appletalk|decnet|
sna|netbios|dlc>] [source-mac
<src-mac-addr>] [source-port
<port-num>] [destination-mac
<dest-mac-addr>] [dscp <0-63>]
[ip-protocol <protocol-
num|tcp|udp|icmp|egp|
ospf|rsvp|igmp|igp|pim|ipsec>
[establish-only]] [source-ip
<SRC-IP-ADDR> [mask-bits <mask-
bits>]] [source-socket <socket-
num>] [destination-ip <dest-ip-
addr> [mask-bits <mask-bits>]]
[destination-socket <socket-
num>] [inactive]>
no classifier <name>
no classifier <name> inactive
Ethernet Switch CLI Reference Guide

Classifier Commands

147) can be used to ensure that a traffic flow gets the
DESCRIPTION
Displays classifier configuration details.
>]
Configures a classifier. Specify the parameters to identify the
traffic flow:
ethernet-type - enter one of the Ethernet types or type the
hexadecimal number that identifies an Ethernet type (see
Table 26 on page
ip-protocol - enter one of the protocols or type the port
number that identifies the protocol (see
establish-only - enter this to identify only TCP packets
used to establish TCP connections.
source-socket - (for UDP or TCP protocols only) specify
the protocol port number (see
destination-socket - (for UDP or TCP protocols only)
specify the protocol port number (see
inactive - disables this classifier.
Deletes the classifier.
If you delete a classifier you cannot use policy rule related
information.
Enables a classifier.
46)
Table 27 on page
Table 28 on page
Table 28 on page
9
M P
E 3
C 13
46)
46).
46).
C 13
C 13
45