DTE Loopback
7976-A2-GB20-10
DTE Loopback loops the G.703 signal back to itself before the signal is sent to
the Framer.
CAP
DSL
All Ones
Port
Transceiver
Procedure
To run a DTE Loopback:
1. Position the cursor at the Start command next to DTE Loopback on the
Network Tests screen.
2. Press Enter.
The Start command is changed to Stop.
3. To manually stop the test, verify that the cursor is positioned at the Stop
command.
4. Press Enter.
A DTE loopback cannot be started when any other loopback test is in progress.
NOTE:
Activating the DTE loopback test causes the EOC to be lost to the remote
unit.
August 1998
CAP
E1
LIU
Framer
Framer
Testing
G.703
Port
98-16000
5-5