G.703 Interface Options Menu - Paradyne HotWire 7976 User Manual

Configuration Option Tables

G.703 Interface Options Menu

Î
A-4
For G.703 Interface Options, refer to Table A-2. To access the G.703 Interface
Options screen, follow this menu selection sequence:
Main Menu Configuration
main/config/G.703
Line Coding:
Line Framing:
Time Slot 16:
Send (AIS) on Network Failure:
Primary Clock Source:
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Ctrl-a to access these functions, ESC for previous menu
Save
Table A-2. G.703 Interface Options (1 of 2)
Line Coding Format
Possible Settings: AMI, HDB3
Default Setting: HDB3
Specifies the line coding format to be used by the G.703 interface.
AMI – Indicates the line coding format used by the G.703 interface is Alternate Mark
Inversion (AMI).
HDB3 – Indicates the line coding format used by the G.703 interface is HDB3.
Line Framing (LTU Only)
Possible Settings: CRC4, noCRC4
Default Setting: noCRC4
Specifies the framing format to be used by the G.703 interface.
Line Framing is only available when the standalone unit is configured as an LTU,
AutoRate is disabled, and the DSL Line rate is 2064 kbps. Otherwise the noCRC4
framing format is used. The NTU is automatically configured to match the framing
format used by the LTU.
CRC4 – CRC4 framing formatting is used for transmitted and received data over the
Network Interface.
noCRC4 – Non-CRC4 framing format is used for transmitted and received data over the
Network Interface.
August 1998
Load Configuration From
G.703 INTERFACE OPTIONS
HDB3
noCRC4
Signaling
Enable
G703 Pt1
G.703
Hotwire
Model: 7976
Î Î
MainMenu Exit
7976-A2-GB20-10