Connecting to the Network
Procedure
To connect your unit to the network:
1. Connect one end of the supplied 8-position-modular-to-8-position-modular network
cable into the rear panel DSL jack.
2. Connect the other end to your DSL network interface.
NOTE:
Do not use a flat VF network cable as this may severely degrade the
performance of the unit. Use only Cat 5 twisted-pair network cable.
Connecting to a DTE
Model DTE Connection
7974
The DSX-1 interface is an RJ48C, 8-position, unkeyed modular connector.
An RJ48C-to-DB15 T1 network interface adapter cable is available from
Paradyne.
7975
The synchronous interface is a 25-pin EIA-530-A interface. Depending on the
cable used, the interface can be adapted to an X.21, RS-449, or V.35
interface.
7976
The G.703 interface is either two BNC connectors (Transmit and Receive) for
a 75-ohm unbalanced interface or an RJ48C, 8-position, unkeyed modular
connector for a 120-ohm balanced interface.
See Connectors, Cables, and Pin Assignments in the User's Guide for specifications of
the connectors and cables.
4