Paradyne HotWire 7976 User Manual page 83

7976-A2-GB20-10
Table A-1. Network Interface Options (2 of 2)
DSL Line Rate
Possible Settings: 400, 528, 784, 1040, 1552, 2064
Default Setting: 2064
Specifies the DSL line rate of the unit.
DSL Line Rate is only available when the standalone unit is configured as an LTU
and AutoRate is disabled (unit is in fixed rate).
400 – The DSL Line rate is 400 kbps.
528 – The DSL Line rate is 528 kbps.
784 – The DSL Line rate is 784 kbps.
1040 – The DSL Line rate is 1040 kbps.
1552 – The DSL Line rate is 1552 kbps.
2064 – The DSL Line rate is 2064 kbps.
NOTE: For associated payload rates refer to Table 3-4,
and DSL Line
Peer IP Address (LTU Only)
Possible Settings: 000.000.000.001 – 223.255.255.255, Clear
Default Setting: 000.000.000.001
Specifies the peer IP address for the NTU, to provide remote management providing the
remote management link on the DSL loop.
Peer IP Address is only available when the standalone unit is configured as an
LTU.
Address Field – (000.000.000.001 – 223.255.255.255) – Enter an address for the peer
unit. The range for the first byte is 000 to 223, with the exception of 127. The range for
the remaining three bytes is 000 to 255.
Clear – Clears the IP address field and sets to all zeros.
Circuit Identifier
Possible Settings: [ASCII Text], Clear
Default Setting: [blank]
Uniquely identifies the circuit number of the transmission vendor's DSL line for
troubleshooting purposes.
[ASCII Text] – Enter a maximum of 128 characters. All printable ASCII characters
except ^ (caret) are allowed.
Clear – Clears the field.
August 1998
Rates, in Chapter 3, Initial Startup and Configuration .
Configuration Option Tables
Fixed Rate Payload Rates
A-3