Linkup And Linkdown - Paradyne HotWire 7976 User Manual

Configuration Option Tables
A-18
Table A-7. SNMP Traps Options (3 of 3)
Link Traps
Possible Settings: Disable, Up, Down, Both
Default Setting: Both
Determines if SNMP traps are generated for link up and link down for one of the
communication interfaces.
Disable – No linkUp or linkDown SNMP traps are generated.
Up – A linkUp trap is generated when the Model 7976 Termination Unit recognizes that
one of the communication interfaces is operational.
Down – A linkDown trap is generated when the Model 7976 Termination Unit
recognizes a failure in one of the communication interfaces.
Both – Sends trap messages for detection of both linkUp and linkDown .
NOTE: Refer to

linkUp and linkDown

SNMP Traps .
Link Trap Interfaces
Possible Settings: Network, SYNC, All
Default Setting: All
Determines if the SNMP linkUp , SNMP linkDown , and interface-related
enterpriseSpecific traps are generated for the network interface, synchronous data
(DTE) port, or both.
Network – SNMP trap messages are generated for the network interface.
G.703 – SNMP trap messages are generated for the G.703 port.
All – SNMP trap messages are generated for the network E1 interface and the G.703
ports.
August 1998
in Appendix B, Standards Compliance for
7976-A2-GB20-10