Initiating An Ati Session - Paradyne HotWire 7976 User Manual

Using the Asynchronous Terminal Interface

Initiating an ATI Session

Î
Î
2-2
The Main Menu screen is displayed on the screen unless a login ID and
password is required or the ATI is already in use.
If the ATI is already in use, you will see a connection refused or
connection failed message (if you are using a Telnet session), or you will
see the IP address of the other user (if you are using the Management Serial
port).
If security is enabled on the Model 7976 Standalone Termination Unit and you
used Telnet to access it directly (you did not log in through the MCC), the system
prompts you for a login ID and password.
Login
Enter Password:
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Ctrl-a to access these functions
After you enter a valid login ID and password, the Main Menu appears. If you
enter an invalid login ID and password after three attempts, the Telnet session
closes or the terminal connection returns to an idle state. Refer to Chapter 7,
Security .
August 1998
LOGIN
Login ID:
Hotwire
Model: 7976
Î Î
Î Î
Exit
7976-A2-GB20-10