Network Interface Options Menu - Paradyne HotWire 7976 User Manual

Configuration Option Tables

Network Interface Options Menu

Î
A-2
For Network Interface Options, refer to Table A-1. To access the Network
Interface Options screen, follow this menu selection sequence:
Main Menu Configuration
main/config/network
Margin Threshold:
Excessive Error Rate Threshold:
AutoRate:
DSL Line Rate:
Peer IP Address:
Circuit Identifier:
––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Ctrl-a to access these functions, ESC for previous menu
Save
Table A-1. Network Interface Options (1 of 2)
Margin Threshold
Possible Settings: –5db, –4db, –3db, –2db, –1db, 0db, 1db, 2db, 3db, 4db, 5db, 6db,
7db, 8db, 9db, 10db
Default Setting: 0db
Determines the level, expressed in decibels, at which a signal-to-noise margin alarm
condition is reported.
–5db to 10db – Sets the margin threshold to this value.
Excessive Error Rate Threshold
Possible Settings: 1E–4, 1E–5, 1E–6, 1E–7, 1E–8, 1E–9
Default Setting: 1E–6
Determines the error rate at which an excessive error rate (EER) condition is
recognized. The rate is the ratio of the number of CRC errors to the number of bits
received in a certain period.
AutoRate (LTU only)
Possible Settings: Enable, Disable
Default Setting: Disable
Specifies whether the DSL line will automatically train up to the best rate or be user
selectable.
AutoRate is only available when the standalone unit is configured as an LTU.
Enable – The LTU is set to automatically adjust to the best line rate.
Disable – The LTU Line rate is user selectable and is based on the DSL Line Rate
selected.
August 1998
Current Configuration
NETWORK INTERFACE OPTIONS
Network
Hotwire
Model: 7976
–3db
1E–6
Disable
400 Kbps
111.255.255.000 Clear
Î Î
Clear
MainMenu Exit
7976-A2-GB20-10