System Configuration - Furuno FMD-3005 Installation Manual

SYSTEM CONFIGURATION

System with one processor unit
Category of units
All units protected
from the weather.
Dashed lines indicate
optional or local supply
equipment.
IF Signal:
- Serial Interface ×4 (IEC 61162-1/2)
- Serial Interface ×4 (IEC 61162-1)
- Digital Out ×6
(power fail/system fail/ NO ×2, NC ×2)
- Digital In (ack in)
*1
: For the monitors available for connection with the ECDIS, see page iv.
*2: When the network complies with IEC 61162-450 Ed.1, the Switching Hub HUB-100 can also
be used. (FMD-3200/3200-BB/3300 only)
Note: When using the EC-3000/3005 as an AMS device, connect an emergency power supply, in
addition to the main power supply.
ii
Monitor Unit *1 Monitor Unit
(Sub Monitor)
(Main Monitor)
ECDIS
Control Unit
RCU-024
or
Trackball
Control Unit
RCU-026
PROCESSOR
ECDIS UNIT
Control Unit
EC-3000
RCU-024
(FMD-3200/
or
3200-BB/3300)
Trackball
Control Unit
OR
RCU-026
(Max. 2) EC-3005
( MD-3005)
100-115/220-230 VAC,
1ø, 50/60 Hz
*1 Monitor Unit *1
(Conning Monitor)
Sensor Adapter
Intelligent
MC-3000S
HUB
*2
HUB-3000
Sensor Adapter
MC-3010A
Sensor Adapter
MC-3020D
Sensor Adapter
MC-3030D
Intelligent HUB
HUB-3000
Radar Connection Box
RCB-002
AC/DC Power
24 VDC 100-115/200-230 VAC
1ø, 50/60 Hz
Serial interface
Analog interface
Digital IN interface
Digital OUT interface
100-230 VAC
Gateway network equipment
(radar, ECDIS, etc.)
Radar 1
Radar 2
Supply Unit
PR-240/241